Sub Woofer Placement
Buy Subwoofer Car Subwoofers
Comparesubwoofer Car Subwoofers Prices
Subwoofer Car Subwoofers Reviews
Cars Subwoofer
8 Inch Car Subwoofer
Car Subwoofer
Home Theater System
subwoofer bridge
Some of the tools you will need include: A hand saw. The crossover fits nicely in between the door panel and the door frame, so just it in. As this book deals with car audio we will be talking about the movement being our speakers.
vibe cbr12 car subwoofer
The popularity of hip hop and other base fueled music has created a need for better sound systems. You usually have to line the enclosure with dense flexible foam or fiberglass insulation which will allow you to achieve the level of damping that is necessary for a good-sounding box. ONLY USE THIS FOR THE SPEAKER WIRES. Remove the radio so that you can access the connections on the back. The rear corners and spare tire well of most cars are a good place to put your subs, and fiberglass can be molded to fit the contours of these areas.
Every car is different, so things may vary. However as the method is the same, here are a few general tips to keep in mind as you plan your speaker installation.
Replacing dash speakers
Most dash speakers are easily replaced by removing the grilles, which are held down by screws or friction fittings. If the grille is held in place by friction fittings, carefully pry it up. In some cases the grille is secured from the bottom by screws, or by plastic studs which can break with excessive force. In such cases, the entire dash panel may need to be removed.
Remove the old speakers, making sure to note the polarity of each terminal. The speaker's positive terminal is the bigger one and usually is marked with a + sign or a colored dot. Use your wiring harness to attach the new speaker, or solder or crimp the connections.
Replacing door speakers
In many cars, door speakers are the easiest to replace. Newer have notched a slot into the edge of the grille. All you have to do is take a screwdriver, pop out the grille, and dismount the factory speaker to get it out.
Step 1.
Remove the grille and factory speaker. Some manufacturers also use a sealant or foam when they first mount the speaker so you might need to cut through that material with a utility knife.
Step 2.
Unplug the factory wiring harness, and attach the Crutchfield wiring harness to your new speaker's terminals. With the wiring harness connected to your new speaker, just plug the other end of the harness into the factory wiring harness.
Step 3.
Check one last time to be sure that all of your wiring is secure, and then screw the new speaker into place in the factory mounting and re-attach the factory grille.