Polk Car Subwoofer
10 Inch Car Sub Woofers Supplier
Car Subwoofer Speakers
Sony Xplod Xs L152p5 Car Subwoofer
Jbl Gto1200b Car Subwoofer
Car Audio Subwoofer Enclosures
Car Subwoofer
Home Theater System
audio subwoofer
System Design The first step that has to be taken when you are designing your own enclosure is figuring out how much space is available in your vehicle. FAQs & Advice No good guide to building a subwoofer box would be complete without a list of commonly asked questions that can help you out. Remove any screws that are holding the dashboard or trim pieces in place. This is a major selling point if you are a newbie. 5" SIDES 2 15.
kicker subwoofer
There are many different types of wooden materials that you can use also, including plywood, particle board and MDF, which is readily available in 4-foot by 8-foot sheet form. Connect the speaker wires to the amplifier. Remove the grille and factory speaker. One option that you will have to consider at this point is the use of the braces for the inside, which, may result in a sturdier box in the end.
This is pretty straight forward so I figured that I would get straight to the point on how to deal with this.
1. Remove the radio so that you can access the connections on the back.
2. Connect the audio cable to the line-out wires that are located on the back of the radio. Connect the red plug on the RCA cable into the red plug (left) on the radio and the black plug (right) on the RCA cable to the black plug on the radio.
3. Connect the 18 gauge wire that is usually provided in the amplifier power kit to the amplifier turn-on wire on the radio. It should be a blue wire on an aftermarket radio. Make sure that you are not connecting the remote turn-on wire to the power antenna wire because it may also be blue. Solder or crimp the connection and then wrap it with electrical tape to protect the connection.
4. Run the audio cable and amplifier turn-on wire that is located behind the dash and kick panel and down the side of the vehicle behind the doorsills to the amplifier. You should tape or wire-tie the remote turn-on wire to the audio cable so that it is easier to run through the vehicle. Run the audio cables down the opposite side of the car from the power wire to ensure that engine noise or other electrical noises do not cross over into the audio cables.