Alpine Subwoofer
Car Subwoofer
Car Subwoofer Kits
Car Audio Woofer
Hooking Up A Car Subwoofer
Car Subwoofer In Home
Build Car Subwoofer
Car Subwoofer
Home Theater System
car subwoofer installation
Newer have notched a slot into the edge of the grille. 5" SIDES 2 19. It must be connected to metal however, so remember that. This is important when building a subwoofer because it is the electrical system that you have to make allowances for and this is the entire reason that you even have a car stereo that runs in the first place. This makes the sealed-box enclosure ideal for many different installs.
in car sub woofer
You will be able to crank the sounds that you want to hear that will let everyone know that you are a force to be reckoned with. Double-check your wiring. Parallel resistances (in this case 4 ohm speakers) will combine according to this equation:Where Rt is the total resistance and R1-R3 are the individual resistances. Amplifier installations can be accomplished safely with the proper know-how and of course, the right tools. Tip 1: To avoid drilling into your vehicle, place a board that is slightly larger than the amplifier underneath the carpet where you want to mount the amplifier. Once you've located those speaker leads, you may want to mark them with tape so that you know which ones they are.
This is pretty straight forward so I figured that I would get straight to the point on how to deal with this.
1. Remove the radio so that you can access the connections on the back.
2. Connect the audio cable to the line-out wires that are located on the back of the radio. Connect the red plug on the RCA cable into the red plug (left) on the radio and the black plug (right) on the RCA cable to the black plug on the radio.
3. Connect the 18 gauge wire that is usually provided in the amplifier power kit to the amplifier turn-on wire on the radio. It should be a blue wire on an aftermarket radio. Make sure that you are not connecting the remote turn-on wire to the power antenna wire because it may also be blue. Solder or crimp the connection and then wrap it with electrical tape to protect the connection.
4. Run the audio cable and amplifier turn-on wire that is located behind the dash and kick panel and down the side of the vehicle behind the doorsills to the amplifier. You should tape or wire-tie the remote turn-on wire to the audio cable so that it is easier to run through the vehicle. Run the audio cables down the opposite side of the car from the power wire to ensure that engine noise or other electrical noises do not cross over into the audio cables.