Car Subwoofer Articles
Car Subwoofer Kits
Custom Car Audio Installation
Pioneer Car Subwoofer
Car Subwoofer Brands
Largest Car Subwoofer
Raw Car Subwoofer
18 Car Subwoofer
Subwoofer Competition
Infinity Car Subwoofer
Car Subwoofer
Home Theater System

car stereo subwoofers
Cut the power wire approximately 6-8" long. It takes about 2-4 hours for this alone. The primary source of power when the vehicle is not running is the battery. This can be tricky at times, but it does not have to be hard.


car sub woofer
Of course, you may now wonder what is next. Like any other component in a car stereo system the ultimate goal of the speaker is to pump up the sound without adding any changes of the original sound to the audio signal. This box should give incredible amounts of output when it is combined with the 12dB/octave boost provided by most automobiles. Then replace the screws, the door pull cup, and the window crank. If we connect (2) four ohm speakers (R1 and R2) in series to an amplifier the total resistance will be:The fact is that installing car stereo equipment is not much fun. Place a drop cloth over any dash, console or front seats that you want to protect from debris.

Subwoofer Info
8 Car Subwoofer Resource
Speaker wire connection

Here is where you learn how to connect the speaker wires.

1. First of all, you have to run speaker wire from the amplifier to the speakers and/or subwoofers that the amplifier will be powering into. If you will be powering the speakers that are already in the vehicle, it's usually easier to run the speaker wire from the back of the radio when you are connecting the audio and remote turn-on cables. Then you have to route the speaker wire along with the audio cable and remote turn-on wire.

2. When you connect the speaker wire to your speakers or subwoofers, you have to be careful to keep the polarity consistent. The speakers will be out of phase and will cancel out each other's signal if you do not connect the positive wire on each speaker to the positive terminal of the amplifier. Usually, one strand of the speaker wire is silver and the other bronze, so you can easily make the right connection.